2019 Veloster PTS Manual, Bypass wont program

Question

2019 Veloster PTS Manual.  Wire to wire according to https://fortin.ca/download/98741/EVO-ONE_IG_RTO_BI_KHY8-VELOSTER_2019_PTS_B_98741.pdf

Bypass wont program when ignition is pressed twice.

Any advice on troubleshooting would be greatly appreciated.

Answer 1

Hello,

What is the S/N to the module?

 

Also looks like there is 2 brown wires in the blue connector, id be making sure you went to the right one.

Make sure you connected the lt.blue/black wire to the ems com wire.

Are you able to program on just the blue led? Let go on blue, plug everything in, turn ignition on. Does blue led flash?

 

Best regards.

Comments

S/n 002B04201778

Quite confident I'm soldered to the correct wire but will verify this evening.

Is there anything else I should look into other than programming on blue LED?

---

Hello,

Flash looks good.

I would try those things mentioned, double check ems com, make sure you grabbed correct wire from evo and try can bus only programming.

Let me know what you find!

 

Best regards.

---

Connected to the correct wire on both the blue factory connector and the blue with black stripe wire on the Evo-one.

No luck with can bus only programming. Light stays solid when ignition is pressed

---

Hi Alex, we just spoke. If you get a minute please send a picture of that 6 pin harness with the reversed wires for pink and yellow to support@fortin.ca

---

This has now been sorted out. Pink ignition wire and yellow starter wore on the 6 pin connector were pinned incorrectly from Fortin.