EVO-ALL PARKING LIGHT RELAY CONNECTION

Question

Looking at the instruccions on Guide # 95081 for 2012 Ford Escape using EVO-ALL and THAR-FORD4 (standard key), it shows Brown/White output goes to a Parking Light Relays. That relay is what's already in the car or it should be added separately?

Answer 1

You need a seperate relay with Evo all.

But if you use an Evo one, the relay is built in, use the white wire from the 6 pin connector.

Comments

Thank you for your help. Looking at EVO-ONE instructions (Guide#95091), I see main connector wires E1 (white) and E3 (red) as optional (dotted lines) for parking lights. Should I connect those as shows the diagram? Not sure how to use the white wire from the 6 pin connector that you mention in your answer. Is the 6 pin connector that T-Harness labeled as B which has no use in this installation?. Thanks again in advance for any help.

---

I am looking at this guide:

https://fortin.ca/download/95091/evo-one_ig_rto_bi_for-escape-2008-2010_key40bits_a_95091.pdf

yes use the red wire to connect to a +12. and the white to parking lights. Remeber there is a fuse inline.

Or just use a relay with evo all.

Your positive 12+ is Blue/Red at ignition switch pin 4.