evo one module won't power up

Question

Hi.. i'm trying to use compustar rf kit to evo one and i modified the antenna wire of compustar according to evo protocol but i plug in to evo one antenna port and i realized that is should use the datalink port instead compustar antenna is not responding so i tried plug the evo one to flashlink if i can change the rf setting but the module won't get any light that power indicating. is there any posible to reset the evo one?

Answer 1

The antenna goes into the small blue antenna port. If it was plugged into the black data port, you may have burnt the datal port which would why it does not connect to the flasher anymore.

 

side note, the EVO should not be connected in the car when connecting it to the flash link.

Comments

Hi Robb.. It was plugged in to antenna evo one blue port and the compustar antenna wire is modified. but in the photo of the modified antenna cable is should be on datalink port but i didn't plug yet the antenna to evo one black datalink port. and it was unplugged the module from the vehicle when i'm trying to connect to flashlink.

---

picture shows blue port so make sure you have the right guide. https://cdn02.fortin.ca/download/25121/rf-p2w902-sp-install-guide-25121.pdf

 

Also, if those are am antenna, you may have needed to flash firmware 0.96. 

 

If you cannot connect at all to the flash link right now, that's normally not a good sign. Do any leds turn on when connecting to the flash link? 

---

flashlink led is on but evo one is not. but if i connect to vehicle the oem fob is working  3x lock start but i have compustar t9 and wan't to use.

---

if the Firstech option is already enabled, press unlock on the oem remote before going to the remote programming indicated in the guide.  https://cdn02.fortin.ca/download/25121/rf-p2w902-sp-install-guide-25121.pdf

 

Also, the T9. We do not list as ever tested. That wire swap may not of even been needed. That kit comes with a crossover cable already and theres no need to then swap the wires again.