2010 RX350 Evo-All PTS Will not program or start

Question

Hello, I have the Evo-All for a 2010 Lexus RX350 PTS

I wired the unit to guide 29991

It was programmed for me with the following oprions (I do not have a programmer):

C1, D1, D1.6, D2, H2

When in programming mode, step 4, the blue light does not flash after pushing the PTS twice, I just get a flashing red light. If i then push the program button once, I get the flashing blue light Push it again, I get the blue and yellow flashing light.

The car does not start but and the red light eventually flashes 3 times.

I have checked my connections four tiems and tried the program mode many times.

Than you for any help you can provide.

Answer 1

Turn on option D6.

Then re program the module and re test.

Comments

Thanks for the fast response.

I am going to have to send it back to the company I purchased it from.

Would D6 being off cause it not to programm correctly in the car?

Answer 2

My aplogy i mis read your question.

 

If you are getting a flashing red led this is an error code we built in to tell us that you have a problem with the rx and tx wires. Either the connection is no good, the wires are backwards or you are on the wrong wires.

Comments

I have checked the wiring and it is definatly correctd based on your diagrams and pictures.

Can it be anything else?

Thank you