All 3 LEDs on EVO-FORT4 with first key in

Question

2014 Ford Flex Std. Key w/EVO-FORT4 Soon as the fist key is inserted all 3 LED's stay lit solid...even all through 2nd key and back to the 1st key during programming. Vehicle can be put in 3rd key programming mode without module installed (door locks will cycle). Key sense wire is good, ignition chime comes on when key is inserted. Tried programming also without red plug plugged into the module. And checked with tech support using SN to make sure the module was programmed correctly. ?? Thank you.

Answer 1

Reset the module and try the programming without the red connector as you mentionned. 

If you can, try to meter the yellow wire when doing the programming, just to see if the voltage is dropping out when you remove the key. This will help further isolate your issue in case a reset did not.

 

Reset procedure, just in case, is as follows:

1. Hold down programming button while plugging in datalink connector.
2. Let go of button when LED is RED.
3. Push and hold button again until all three LEDs start to alternate.
4. Disconnect unit, she is now reset.