Invalid key data

Question

Since I had a lot of trouble connecting the RF kit to my EVO-ALL, and at some point flashlink said the device could no longer be flashed, I bought a new EVO-ALL module, which today I received.

Now I tried to program the device, everything goes according to the manual, but when I reconnect it to flashlink to start the decryptor, it says invalid key data, I tried several times, and everytime the same problem, I did not have this once with the previous device. Any suggestions?

Answer 1

Simply try re programming it in the vehicle and then re run dcryptor.

 

This can happen sometimes when it doesnt aquire all the info needed in the initial in vehicle programming.

Comments

That did it, everything works now, thanks!

---

Glad you got it going.

 

Best regards.

---

Glad you got this up and running!

 

Would it be possible to post the PC spec? Like windows version? Approx age of PC? Black, Blue or Yellow USB port?

---

it's a 2019 HP Spectre X360 with windows 10 x64 latest updates, USB port is black but I think it's a 3.0

Like mentioned this one is the second one I buy, the other one programmed fine the first time, and I reflashed it many times because I had issues with learning the RF remotes, all worked fine with factory remotes, then learned the RF ones and nothing worked anymore, only could reset by reflashing, after like 20 tries with the exact same result, it said it couldn't be flashed anymore, so that's why I bought another module. After a few days of trying, I suddenly got it reflashed again and after that everything worked instantly strange enough.

Since I had ordered the second one, I decided to keep this as a backup, that's why I wanted it completely programmed. I have tried exchanging them and everything still worked, so that seems ok now.

---

Thanks for the info!

 

The flash limit is resetable if you send the service number to support@fortin.ca