Connecting ACC from Alarm to EvoAll-TharCHR5 Wrangler

Question

I have installed on my Wrangler 07 a PKE  EasyGuard EC002 with a Push button Start and Hard Wired to EvoAll-TharCHRT5, I got everything work but ACC mode.

I didnt know where to connect my ACCesory + Output from my Alarm to EvoAll and chose wire to Lose Yellow wire on Thar-CHR5 harness.

But when I select ACCesory mode on push start button  (1 click no foot on brake) the car goes directly on RUN mode, which I guess is because I wired to the Yellow Wire which is RUN mode and not ACC.

In wiring information of Wrangler 07, it use a single MUX cable to send the signal of ACC and START, according with that, to get ACC Mode it has to Ground wire throught a 560 resistor and a 150 ohms resistor to START

So I guess I have to use a relay to convert the ACC + mode to ground plus the 560 resistor and maybe the MUX Green/Red Cable (A18)?

How can wire my ACC output from Alarm to EVO to set the ACC Mode the right way?

TIA

Answer 1

The evo-chrt5  was deisgned for remote start.

 

To my knowledge the evo-all has no input for accessory mode.

Often times with after market pts system you run into configuration issues like this.