2022 Jeep Wrangler 4XE wont start 3x oem remote EVO ALL chrt7 harness

Question

Good day,

I have the Evo-all chrt7 harness. I updated the firmware to 69.06 saved my settings, went to car followed the instructions perfectly, lights did what they should have done, ran the decryption said it was successful, plugged back in to car. It will not remote start. When standing outside looking in the window it says push brake then push to start? I did not install the hood pin since, the jeep already has 2 from the factory, I assume I did not need to. is there a setting Im missing?  I have A11 off, A1 on A2 On, A3 On, A4 Off, A5 to A10 On, D1 On, C1 On, D4On, Data protocalls off. Please advise?

Thanks,

Kevin

Answer 1

What is the S/N located on the back of the module?

Comments

Sn 001A07 388403

---

I would suggest calling in when you have the vehicle and module on hand to go over the installation/programming with a tech on the line.

 

Looking at the set up and programming it appears to be ok.

 

1-877-336-7797

mon - fri

9-5:30 est

---

Thank you,

I spoke to Tech support and they walked me through it.  Works Perfect now. Apparantly I was not supposed to upgrade to the new firmware. The one that was on it, is what works. Had to do a factory rest, re-install old firmware, settings then followed the programming procedure and works perfect now.  Thanks for the help