2018 Passaat-Skoda octavia

Question

Hello. I wanted to install evo-all on 2018 skoda (standalone). I registered both 66-04 and 67-04 (Passat) for two devices (001A07246895 ... 001A06895330). I connected both the ignition wires and the can wires. The CAN wires were in the BCM connector (orange-green to gray and orange-brown to grey-black). I release the button to blue, and as soon as I open the ignition, the blue goes out and nothing else happens. When I turn off the ignition, the blue lights up again. What to do?

Answer 1

Hello,

For a 2018 passat standard key, you would need ignition, can hi and can lo. Refer to this installation guide on where they should be connected: https://fortin.ca/download/33101/evo-all_ig_reg_bi_vol-passat_2015_key_f_33101.pdf

 

If the blue led does not flash then you have a connection issue with either can hi or can low (backwards, weak connection, etc).

 

Best Regards.

Comments

Nothing helps. Now I connected them all at the ignition switch. Vserovno after turning on the ignition, the blue goes out, I wait 2 minutes. Nothing changes. I turn off the ignition and the blue lights up again. I also tried 61-12 and 61-19 firmware.                         2018 Skoda

---

Try flashing the evo with firmware 75.41, turn off a3 and re attempt programming.

---

Well done you. All OK. The client was gone. I called him and he came back. Thank you so much. So when I leave the key in the car, I can always disable the A3, right?

---

I turned the A3 back on again -- The owner had a spare key at home. Everything has been corrected.