I can't program the device for 2013 Ford Mustang

Question

Hi I have an Evo-All product,

I updated the device with flash link by choosing Ford > 2013 > Mustang > Automatic > Standalone Remote Starter Only > 3x lock remote start > No RF Kit

Decryiptor YES
Key Programming 1

Regarding the guide (https://fortin.ca/download/72091/evo-all_ig_tsa_bi_for1-mustang_2010-2014_c_72091.pdf)

- I release the button when it's red.
- I attached remaining cables
- I click button once
x red light is not flash
x I tried anyway I put key and open Ignition however It did not do any action.

Here I tried to explain

https://youtu.be/s7O73kwiCX0

Yesterday I tried to program 2 keys. Also no success :( However I clicked lock button 3 times. After that car gives immobiliser error. When I put my car key manually, car started automatically.

After car started I clicked 3 times lock button again then car stopped.

Here also another demonstration about that

https://youtube.com/shorts/qOaY6rogeyM

Demonstration for 2 keys

https://youtu.be/_3ikxnDdltQ

The firmware on the device is 71.52 [recommended]
Hardware inside 7.0

Hope I could explain good.

Best regards

Answer 1

Hello,

 

Looking at the video it would appear that you never connected the yellow, lt.blue or lt.blue/black wires from the 20 pin connector to the t-harness (page 4).

 

https://fortin.ca/download/72091/evo-all_ig_tsa_bi_for1-mustang_2010-2014_c_72091.pdf

 

Best regards.

Comments

Hi Derek,

 

Thank you for your reply.

 

If I understand good, just to clarify;

 

Light blue --> Light Blue
Light blue/black strip --> Light blue/black strip
Yellow --> Yellow

Connections are mandatory, right?

Hereby I send more clear picture about thar wiring. Since I only need remote start with my car key, other cables are optional I believe.

This should be fine If I'm not wrong, what is your opinion?

Image URL

https://ibb.co/bL8zzY3

 

Thanks a lot.

---

Here I try to send image

 

Image URL
https://ibb.co/bL8zzY3

Answer 2

Hi @Derek,

 

Now I tried and succes.

 

Actually previously I had the same cable connection but I used cable scotch lock. I believe it did not establish the connection. Now I just attached the cables to eachother with normal way and it worked.

 

Thank you

 

Best regards