Evo-all for atlas 2021 can’t programmed

Question

I bought the evo-vwt6 kit and followed the instructions at https://fortin.ca/download/92391/EVO-ALL_IG_RTS_BI_VW_ATLAS_2018_PTS_B_92391.pdf.

I opted for the steering wheel heating version.

I loaded firmware version 61.28.

I followed the programming instructions, but on step 5, I never saw a rapidly flashing blue LED.

What might I have done wrong?

I read on forums that this could be a sign that it's not detecting the CAN bus.

I also found discussions about VW removing the CAN bus from the steering column.

Please help me find a solution to this issue.

Answer 1

Does the vehicle have the heated steering wheel? If no, you need to use the other connector.

Comments

It has a heated steering wheel, and I connected connector B. Connector A has a different shape and cannot be connected.

---

You can test the CAN signals,
What's the voltage on the grey and grey/black wires of the 5 pin white connector on the evo? Ignition will need to be on to test.

---

Yes, I measured the voltage. It's approximately 4.4 volts between the gray and gray-black wires with the ignition turned off. When I turn off the ignition, the voltage disappears.

---

4,4 volt with ignition on

---

Do you have any suggestions? I wanna finish installing and use remote start