Lock/Unlock doesnt work when ignition is on but works fine with ignition off.

Question

Just installed an Evo one and T harness on my 06 Tacoma V6 auto. The lock/unlock functions work fine when the ignition is off from the Fortin remote. Remote start works fine as well but won't lock/unlock once the ignition is on. I verified lock/unlock also doesn't work when the ignition is on with just the key. The door lock switch still works fine with the ignition on. I can hear the Evo pulse the locks and the marker lights flash, but the locks do nothing when using the Fortin remote. I got the unit as a kit online with RF 642w remotes preprogrammed. The bypass was below the recommended firmware, so I updated it with my Flash link to 79.70. Remote start was at recommended level. I tried lengthening the lock pulse with no change.

Answer 1

Hello,

This happens when you grab the wrong door lock wires.

Try these:

Lock/arm: Violet, driver kick, white 10 pin connector, pin 4

Unlock/Disarm: Green/Black, driver kick, white 10 pin connector, pin 8

 

Best regards.

Comments

Those are the wires I'm using. Solid purple to solid purple and purple/white stripe to green/black stripe. Anything else you can think of?

---

Yes, try these ones in place:

Lock: Blue/white, driver kick, white 10 pin connector, pin 6

Unlock: Grey, driver kick, white 10 pin connector, pin 7

---

That combo works! Thanks for your help.