When i try to remote start after install a blue light flashes on module but Jeep does not start

Question

I finished installing and programming my remote start on my 2020 Jeep Wrangler w/o keyless entry. I have the after market remote start remotes and when I go to start it a blue light flashes once on the module but the Jeep does not start. Dash screen light comes on and so does the lights by the gear selector but that’s it.

Answer 1

Is this your unit? 001A07543001

Couple of unit options are missing.

• Option D1 - Stand Alone Remote Starter
• Option H and H2 - Fortin2 supported RFKIT  (assuming you are using a Fortin RF-KIT)

When flashing via the Wizard Mode, select "Stand Alone Remote Starter" under system setup and be sure to select an RF-KIT.  The module and remotes may need to be reprogrammed afterwards.