VW Jetta 2015 - No Key even after Decrypt seems to have worked fine

Question

I have installed a EVO ALL on a Jetta 2015 TDI (Push Start - Automatic).  I have the EVO ALL, THAR-VW1 and TB-VW installed as per instructions (I decided to skip the trunk release wiring as I didn't find the feature useful for me case).   The EVO All is programmed with Diesel Option enabled and it went through the Decryptor without any issues.  

When I press the 3 lock sequence,  the dash lights up (I had a previous problem that now brought me up to this point) but the dash says 'NO KEY'.   The car starts if I get the key in the car,  but not if the key is not in the car.   I was wondering what could be the problem.  The only item that I was wondering is that I reprogrammed (changed options) on the EVO ALL but didn't run the decript after,  would this cause this issue?   The car is store off site so I will drive in the morning and try this.   But what other issues could this be?

Answer 1

Make sure the TB-VW 4 pin connector is fully seated.

What is the 12 digit serial number of the evo-all?

Comments

I just checked the 4 pin and it is seated fully.  

The serial is: 001A07 609412