caravan-programming 001A06-360033

Question

I am using the autostart remote starter with the fortin evo all bypass. I have the remote starting working except for programming the bypass. I am using the d2d connector to share data from the autostart to the fortin. Following the instructions of plugging in the 4 wire connector and holding the programming button, i stop at the blue LED. I connect the 20 pin , then the 6 red pin connector. The blue LED then stays on and i turn the igntion switch on. The blue LED  goes out and then nothing happens. I have done this many times and the result is the same. The bypass will not learn the skim code as it is described in the instructions .

I am at a loss .

PLease help .

Thanks.

Answer 1

Check can high and low make sure not crossed and make sure have 12 volts ignition on yellow to evo and make sure have power to win on blue red.

Comments

Thanks for thecomments . This is not a can vehicle.It is a j1850 single wire.

I have read someone else with 2004 ram truck had same issues as i. They were told they have the wrong firmware. My firmware is 4.18. I wonder is my frmware wrong.

Answer 2

Hi Mark,

The J1850 vehicles requires 4.06 in order to program. There should be a mention of this somewhere on the connection in the installation guide.