2007 Dodge RAM - 6.7 L Diesel - EVO-ALL w/autostart - starter drags on indefinately

Question

EVO-ALL seems to program normally, Firmware 4.18 Hrdwr Vr 6.0 - remote starter (M/T truck) sets up, takes over, but the starter DRAGS badly untill you shut it down with brake. Attempted to re-learn tach (EVO-ALL pink) - Autostart reacts normally to tach programming - pulled EVO-ALL, re-flashed with recommended update with the Flashlink Manager. THis 2007 truck has no start line. But what might bother me is this truck had a previous system installed and the MUX line is modified with a piece of wire soldered in as the old system had been chopped out and about 12" of that ppl/brn has been replaced with another simillar guage wire, wondering if the MUX line could be compromised?

Not sure what else to do?

Thanks for your input..

Answer 1

Hi Derek,

 
If you are not using a Tharness and since there is no (+)Start at the ignition switch, you should be using this install guide:

http://ifar.ca/download/9671/evo-all_chrysler_dodge_jeep_%28skreem_no_t-harness%29.rev-20130605.pdf

 
If you are using a Tharness and since their is no (+)Start at the ignition switch, follow the appropriate connection. Which i believe is connection A or B depending on if you are using datalink or not.

http://ifar.ca/download/7711/evo-all_thar-chr5_%28t-harness%29.rev-20130219.pdf

Comments

You can also test your MUX line with a multimeter if you want. I cant remember the values off the top of my head, but they will vary depending of key position.