Questions & Answers

2014 Accord Standard Key will not remote start, red and yellow LED on

0 votes

Hello, I am having a remote start issue with a 2014 accord using the evo-one with the thar-one-hon2 harness The unit was flashed by the selling dealer lessco electronis.  I do get blue lights when pressing the lock/unlock. When I try to remote start it, the red and yellow LED will on. It just unlock the car and relock it. It is not crank. Whats wrong with it?

asked Jan 2, 2015 in Honda by Vincent Ma (520 points)

2 Answers

+1 vote
Lessco had options wrong in my module which prevented remote start. Better double check with the flash link. Option 38.2 and OEM remote monitoring must be enabled. Also found out on my accord lock,unlock lock option for starting does not work.
answered Jan 3, 2015 by Lastminuteracin (650 points)
Have you connected parking light wire? I connected pink wire to grey wire.. But, it doesn't work.
commented Jan 3, 2015 by Vincent Ma (520 points)

I did not hook up parking lights on mine. Here's a good link 

http://www.the12volt.com/installbay/forum_posts.asp?TID=137247

 

I believe this is the correct location and color. Double check with a meter  

PARKING LIGHTS ( - ) GRAY (-) @ HEADLIGHT SWITCH, WHITE 12-PIN PLUG, PIN 8  
commented Jan 3, 2015 by Lastminuteracin (650 points)
edited Jan 3, 2015 by Lastminuteracin
Is your remote start working? Did you enabled D2 Unlock before/lock after (Disarm OEM alarm) option in flash link? Did you connect lock and unlock wires?
commented Jan 3, 2015 by Vincent Ma (520 points)
edited Jan 3, 2015 by Vincent Ma
Yes d2 is enabled and yes I hooked up the lock wires. I am using both the factory key fob set to 3x lock and the revo start revo-4 Rf kit. Are you sure you have option 38.2 on in the remote start side? Start the flash link manager. Hit toggle at the bottom. Hook up the evo. Click configuration then options. Enable 38.2 3x lock. I believe you can do it from the bypass side by selecting configuration then options as well.
commented Jan 3, 2015 by Lastminuteracin (650 points)
edited Jan 3, 2015 by Lastminuteracin
You got it! They didn't enable 3X lock button remote start. I did it. Then, it works. Thank you so much!
commented Jan 6, 2015 by Vincent Ma (520 points)
No problem. Glad it worked out
commented Jan 8, 2015 by Lastminuteracin (650 points)
0 votes
Does ignition in the vehicle turn on? Did you connect parking lights? If you did, they will flash X amount of times on failed starts.
answered Jan 2, 2015 by Robert T (302,310 points)
It doesn't turn the ignition on. I have connect parking lights. But, I'll check that again. Becuase, my parking light wire color is not the same as installation guide.
commented Jan 2, 2015 by Vincent Ma (520 points)

Related questions

...