Questions & Answers

evo fort1 thar- for1 cant program

+1 vote
i installed stand alone system with thar- for1 in my 2012 Ford focus(auto transmisi on) after last step of programming , when i push program button ignition is going on but 'immobiliser active ' alarm caming . evo lamps blue-red lighting where is the problem? my evo version 6 firmware. 7-29
asked Dec 17, 2015 in Ford by kaga baba2 (250 points)

1 Answer

0 votes
Typically caused by can-bus connections being reversed or not connected properly.
answered Dec 17, 2015 by Robert T (302,310 points)
dear sir

i have 1 master key and 1 spare key(not remote ) which procedure i must do for programming and also in wiring diagram shows to connect lock-unlock wire and RAP / Factory Alarm Control connection , but youtube videos only connecting can high and can low connection , must i conect all of them ? or only can high and low is enaugh?
commented Dec 18, 2015 by kaga baba2 (250 points)
The installation guide has all the proper connections. We do not have youtube videos.

You may need to do the 1-key programming with DCRYPTOR.
commented Dec 18, 2015 by Robert T (302,310 points)
dear sir today i connected all wires and tryed again when turn on position first key three lamp lighting together after when turn on position second key blue and red lighting together then i am pushing programming button ignition being on but screen writing 'immobiliser active look handbook' alarm caming and fortin still lighting blue and red i tryed second key first , all thing is same what is wrong please help my car europen car is it different?
commented Dec 19, 2015 by kaga baba2 (250 points)

Related questions

...