Problem installing EVO-ALL in 2012 Ford Mustang Please help?

Question

Installing EVO-ALL in 2012 Ford Mustang.  Did not work with instructions from box.  Went through tech support wire connections good.  Tech support said I need to install using Dcryptor procedure & Flash Link 2.0.  Went through steps 1-8 to program key in module all lights flashed correctly through this process.  Connected Flash Link went to updates selected Ford Mustang 2012 and then selected the recommended update 71.32 and updated.  Said EVO-ALL update successful.  Disconnected from Flash Link and re-installed in car.  When all wires connected no lights.  When push lock button on key 3 times blue light flashes each time but no start.  When pt key in ignition no lights.  Turn key to run get yellow light.  When start car still yellow light.  First time I started car When I shut off the key and pulled key out of ignition car continued to run so had to disconnect EVO-All for car to shut off.  The car now starts and shuts off even with EVO-All connected but no remote start.  Can you help me to get the remote start to work?

EVO-ALL Service No. 001A06537118

Flash Link Udater Service No. 002503026333

Answer 1

are you using the evo as stand alone? If so options C1 and D1 need to turned on and it looks like you didnt complete the decryptor process, i would perform a master reset, change your options and reprogram to the vehicle then complete the decryptor programming

Comments

Thank you for your reply.  I did not get good instructions when they sent me the Flash Link Updater.  I found where to complete the Dycryptor process with the flash link and completed it I then turned on C1 and D1.  The remote start works now.  Thank you so much.