Questions & Answers

2012 Camry PTS - Programs and reacts to remote, but won't start (EVO-ONE)

0 votes
Fortin EVO-ONE, being used for OEM 3x lock functionality.

Service No: 002B05 027724

Flashlink settings look okay from what I understand.

So my current situation is this: Unit installed fine, programming went fine, but now won't start after 3x lock. When I press the lock or unlock on my OEM key, the Evo-one will blue-flash accordingly as I'm assuming it's intended, but after 3x lock, nothing happens at all. Also I seem to get a slow red flashing light from the unit (doesn't seem to come from the 3 leds on the front, seems closer to the yellow loop).

The yellow (automatic) loop IS cut, and again it does respond to the lock/unlock on the OEM remote, it just won't start with 3x  lock.
asked Feb 3, 2016 in Toyota by Sean S (190 points)

1 Answer

0 votes
You need to set option 38 to 38.2 on the remote starter side. You are currently at 38.4, this wont work.

Also looking at your service number you did not enable option C1 on the bypass side.
answered Feb 3, 2016 by derek g (324,940 points)

So I got it to react to the remote, but now it won't start. I've tried a few different settings/flashes but no luck.

 

As of right now, what will happen is either:

A)Blue led reaction to remote, and 3x lock goes red. The parking lights will come on and the car will go to ignition for a few seconds (No engine starting, just gauges and such will light up), then it all shuts down and I get 4 parking flashes.

OR

B)Same as above, except sometimes the car will stay on in ignition, but will not react to remote any more. The only way to turn "off" the car is to press the brakes from the inside (Note this situation only happens when I am inside the vehicle)

 

I've tried a few settings changes such as tach setting and "unlock/lock around rs to get past alarm" but I still get this same scenario as above.

If Ignition is coming on but the vehicle is not cranking then I would verify your connections to the steering lock wire, if this wire is not connected properly it will prevent the vehicle from cranking.

Thank you.
...