Français

Questions & Answers

2016 Ram wont start service #001A06 506999

service #001A06 506999 firmware 74.24 evo all and thar-chr6 with astrostart remote evo programmed properly when remote starting evo red light turns on but doesnt crank or start ignition not turning on. evo is not getting ign signal from remote (diode installed as per diagram). when i supply evo with ign on yellow wire truck starts and runs. yellow wire is also connected to pink/green wire on truck. is this a diode issue? with diode installed properly the evo wont recieve ign signal from remote.

closed with the note: problem solved

asked Feb 23, 2016 in Ram by Douglas Buhs (310 points)
closed Feb 23, 2016 by derek g

1 Answer

Did you check the wire you connected to in the vehicle too see if it is a ignition wire?

answered Feb 23, 2016 by derek g (346,760 points)

yes it is the pink/light green wire #6 pin in 10 way connector it is 12 volts key on

commented Feb 23, 2016 by Douglas Buhs (310 points)

Do you have a flash link updater?

commented Feb 23, 2016 by derek g (346,760 points)

yes the evo has been flashed to latest software and encryption done

commented Feb 23, 2016 by Douglas Buhs (310 points)

try flashing it the module to 74.22 and re program the module start to finsh including dcryptor. Tell me what the led's on the modle do when remote starting.

commented Feb 23, 2016 by derek g (346,760 points)

flashed to 74.22, reprogrammed and dcryptor. when remote is activated evo red light is on solid and then astro start shuts down after about 10 seconds

commented Feb 23, 2016 by Douglas Buhs (310 points)

Have you tried the evo in stand alone?

commented Feb 23, 2016 by derek g (346,760 points)

no if i remove or reverse diode remote starts properly evo is not getting ign signal from remote it is getting a start signal but the remote shuts off due to no rpm signal

commented Feb 23, 2016 by Douglas Buhs (310 points)

Did you use a t-harness?

Try it in stand alone enable option C1 and D1...This will tell us if its a remote start problem or bypass issue.

commented Feb 23, 2016 by derek g (346,760 points)

thar-chr6 t-harness does rap connection need to be made for stand alone

commented Feb 23, 2016 by Douglas Buhs (310 points)

no not mandatory

commented Feb 23, 2016 by derek g (346,760 points)

in stand alone truck remote starts

commented Feb 23, 2016 by Douglas Buhs (310 points)

ok so know we know its an issue with your remote start!!

are you using data or wire 2 wire?

If using data what protocol is your remote starter/evo-all set too?

commented Feb 23, 2016 by derek g (346,760 points)

i just flashed to 74.19 truck remote starts now with diode installed as per diagram may have a software isssue with 74.22-.24 Thanks for the help and info

commented Feb 23, 2016 by Douglas Buhs (310 points)

...