Immobilizer and evo-start not programming

Question

When I first programed the immobilizer thru DCryptor it all went fine and was working. I tried to program my evo-start, after step G (press and release brake pedal) the antenna LED never flash blue. Tried like 20 times without any luck, when I send a request with my phone the antenna blink green fast than amber for 2 seconds or if I press and hold the button on the antenna the LED turn on green than flash 7x amber. Both code have in common that it may not using the good protocol.

Now it will crank but no start, I tried redo the DCryptor process, did it 10x every step looks good but I always get a message saying the immobilizer data is incomplete.

Now my question is how do I get the immobilizer to work again and the Evo-start. I don`t know if the module is bad or what but I`m having hard time to program it since the beginning, sometime it work next time it won`t. It my first Fortin,  I did few Autostart before.

It on a 2016 Honda CRV PTS and it has the T-harness. Thank you

Answer 1

Instead of pressing the brake, apply 12V to the small black wire from the 20-pin connector. See if the led starts to flash this way.

Give us a call if this is still not solved

Comments

I think I may have found my problem just need to confirm, I had the module removed and the vehicle start then died with the green key in the cluster blinking. I removed the T-harness and it all came back to normal. My harness was probably the root of all my issue. I will rewired everything without the T-harness and retry. Thank you