How to keep ready mode on?

Question

I installed an axxess evo-one and added the rf641w remote kit to my son's 2017 honda civic si with manual transmission. The install went okay and everything works. The problem I have is that I put the car in ready mode and after I test the remote start, the car starts fine. I drive the car and when I return and shut off the car I make sure that I leave it in nuetral and the parking brake is engaged. When I go to remote start the car again the lights flash 3x which means that the car is out of ready mode. I shut off the D3 command via the flash link as suggested by Derek but the problem remains. Does that mean that everytime I'm going to exit the car I have to go through the steps of putting the car in ready mode? If that is the case than I will remove the unit. Has anyone else had this problem?

Answer 1

Turn off option D3 in the bypass and re test.

Comments

I turned off the optionD3 but Im still getting the same results.

---

I too find this annoying,  is there a way to bypass this at all?

---

Not unless you want to kill someone.

 

Ready mode needs to be enabled when the car has been driven or if a door has been opened.

---

Really?  Why post such a stupid comment?  Oh yes, im going to go into my car, toss it into a gear then leave it to remote start it later?  Morron.  Im the only one with access to my vehicle, I dont park it in gear because of the remote starter and clearly you cant leave the car in gear to activate readymode.

---

Not being a moron. It's already happened that the "i do not leave it in gear" comment failed someone.

Answer 2

We're you able to keep ready mode on? Is it as simple as cutting the yellow loop to put into automatic transmission mode?

Comments

Ready mode needs to be enabled anytime after the car has been driven,.