Questions & Answers

Remote start not working

0 votes

I was able to program the evo and connect it to my Compustar alarm. It now locks and unlocks through alarm. But when i try to use remote start it turns on ignition to run position but does not start. If i open door it turns off the ignition like it is suppose to. Guessing that is a setting in the programming but not sure which one.

this is for a 2013 dodge journey sxt push button and using a compustar CS6900-AS

asked Apr 21, 2018 in Dodge by Angel Enriquez (440 points)

1 Answer

0 votes
What protocol are you using in the Compu unit?
answered Apr 23, 2018 by derek g (346,560 points)
According to the manual the Compustar CM600-AS,which is the actual unit used in the CS6900-AS, only uses ADS or fortin. I don't have a way to change it so i would assume that ADS is the default.
commented Apr 23, 2018 by Angel Enriquez (440 points)
Have you chekced to make sure it is indeed in the ads protocl? or better yet just set it to ads protocl to make sure.... Assuming things can sometimes come back to bit ya....

 

Also what happens if you place the evo in stand alone and try to remote start it using the factory key fob?
commented Apr 23, 2018 by derek g (346,560 points)

Related questions

...