Questions & Answers

Evo CHRT5 on 2015 Wrangler does not flash after turning key to on and off

0 votes
I started installing my remote starter and everything goes according to the guide, i get solid blue after pluggin in the EVO to the immobilizer, step after that the evo stays on solid blue after i put the key in turn to on and then off. i dont start the vehicle obviously but the light stays blue a solid bue.

I have the 4 pin black plug, 20 pin while, red plug and the 4pin white, in the instructions it says plug in the 2pin white connector which was not in the box. i ordered the right one for my Jeep, am i missing something? or do i need to do a different step.
asked Nov 3, 2018 in Jeep by Raed Atallah (200 points)

1 Answer

0 votes
You want to ensure you flashed the proper software version 4.18 or 74.07 and make sure the ignition yellow wire from the evo is hooked to the remote starter and t harness there shouldn't be a two pin connection required
answered Nov 3, 2018 by trevor gorniak (2,230 points)
So does that mean that the unit does not come flashed with the program when i bough it? I bought it from fortin
I.connected the yellow wires and the unit went through the programming cycle. Now when I try to start it I see the red alarm light flashing in the dash and the jeep doesn't start. Any help will be appreciated
...