EVO ALL CAN Bus confusion

Question

Good evening,

 

I am wiring up an EVO All with a Viper 4706V on a 2015 KIA Sorento. I am confused on the CAN1 and CAN 2 locations. According to guide 10841, CAN1 is located on the back of the fuse box, and CAN2 is located on the ODB-II connector. Yet, WIRECOLOR.com shows the opposite. And looking at the standard pinouts for ODB-II, it just shows can bus high and low on the ODB-II, no 1 or 2 spec.

Anybody out there do one of these installs? Not sure which doc to trust here...

 

Thanks,

Jim

Answer 1

Go with the guide.

Comments

I was just about to update this post!

 

I went with the guide and everything worked just fine. Thanks!

 

Jim