evo one firmware version updating to recommended version but showing 0.00 after flashed

Question

evo one firmware version 1.24 was compatible when i plugged it to flashlink again to make some setting changes but now showing firmware is not compatible so i update to recommended firmware 1.25 but now firmware is showing 0.00 after updated to flashlink and still flashlink is suggesting to update to recommended firmware 1.25. so i updated to 1.25 version again and still showing 0.00 after flashed. i lost 3x chance flashing in this hardware on the remote starter side. anybody can tell me what is going on about flashlink or my hardware..

Answer 1

what is the service number of the evo-one?

Comments

Service# 002B07034481

---

Thanks Robb! firmware is now updated!

---

It shows as being updated on my end.  Restart flash link? Make sure you have 4.51 installed. 

 

 

 

---

i can't get solid blue led on programming step 1 to 3 when i release the programming button blue led will off for 2008 dodge ram 2500 diesel. i checked all my wiring and they are on the right connection aside parking light i didn't use it. am i on the right firmware? i don't think i can still flash my firmware on the bypass side i has 8/8 already

---

If blue turns off by itself after releasing on blue, it's because the module sees ignition on already. Check your A1-yellow and e5 pink connection. Meter the wire as well. should only be 12v when key is on.

 

Your module is reset.

---

could I get a module reset as well. I am stuck with a red LED on only and can not do anything.  any help would be appreciated.s/n 001A07 200763

It was preprogrammed with the following:

Firmware: 70.XX

type GMC/GM/Buick PTS

for a 2018 chevy Equinox for remote start