Lexus RX350 2009 Firmware in Manual is not an option in Flashlink Manger 4

Question

I have Flashed the INT-SL+ with 0.17 via the instalation manual Guide#90081

It says to load Firmware 79.65 to the EVO-ONE. The highest option available is 79.56.

I cannot get he INT-SL+ to program to the car via the lock button.

The EVO-ONE will learn the key and flash red 10x, but when I go to the next step to hold the programming button on the INT-SL+ then connect connector 1 and keep holding while connecting connector 2. The Led is supposed to light up, but nothing happens.

Answer 1

If the int-sl+ does not light up when holding down the programming button and plugging in the data link, first thing to verify is if you have power and ground on the black 4 pin data link cable. red = power, black = ground.

 

79.56 will work fine in a vehicle of that age.

Comments

Hey Derek, I have power and ground on the 4 pin connector, but the INT-SL+ does nothing. if I reprogramm the firmware I can get it to respond, but I dont want to do that again because I only have 4 flashes left.

---

I having trouble to get the int-sl+ to program. Got LED lit on when plugged in connectors, but when pressed lock button nothing happened.