Questions & Answers

Fortin EVO GM4 on Silverado 2500HD W/T will not start engine but controls door opening and closing

0 votes
I need help with this... I have programmed and installed fortin evo GM4 in my chevy 2500 11”, the blue light comes on every time I press the 3X control but the engine does not start… so what could it be??
asked Apr 9, 2022 in Chevrolet by ignacio oneil (130 points)

1 Answer

0 votes
What is the S/N number located on the back of the module?
answered Apr 11, 2022 by derek g (347,180 points)

service number: 002505 097149 (flash-link), Fortin EVO ALL serial number: 001A07 331195.

I see 2 problems:

 

1- You've maxed out the dcryptor limit for the module, meaning the module is not currently programmed properly to the vehicle. I will get this reset for you, it takes up to 24 hours. Once done you will need to reprogram the module to the vehicle from step 1 all the way through re running dcryptor.

 

2- 3x lock was never turned on. For it to function you must enable option D-1.10.

 

Once both of these things have been done then re test your 3x lock start.

serial number: 001A07331195.

I have the original control of chevy the rf kit which option should I select?  thank you !
What RF kit are you using?

 

You still have not re programmed as mentioned above and you are still missing the option I mentioned above.
I do not have Rf kit, I use the original dob remote control of the chevy

I see 2 problems:

 

1- You've maxed out the dcryptor limit for the module, meaning the module is not currently programmed properly to the vehicle. It has been reset for you. You will need to reprogram the module to the vehicle from step 1 all the way through re running dcryptor.

 

2- 3x lock was never turned on. For it to function you must enable option D-1.10.

 

Once both of these things have been done then re test your 3x lock start.

...