Missing wire color/location and diode install

Question

Good day.  2013 Explorer.  Install instructions show brown/wht wire from module to parking light relay negative but does not identify wire location on vehicle or wire color for vehicle wiring.   Also, for the lock circuit (white/black) shows a 1A diode.  Is that built into the module or is this something I must add? (A19).  Finally - on the OBDII connector for can low and can high - the wire colors are NOT the same as the diagram or schematic.  I did confirm the postions identified in the instructions are correct with respect to can low and can high.   Just want to make sure there is no issue with tis discrepancy.   Many thanks for your assistance.  Mike Grima  mjg104@att.net

Answer 1

Which guide number are you following? The Evo One and Evo all guides both show parking light information, The diode is only built into the Fort4 harness, otherwise, you need to add it. OBD wiring will always be the same by pin position  3 and 11, viewed from the front