Proper 2012 f150 install guide for evo-all Thar -For1

Question

What is the proper install guide that I should follow to install the evo-all thar-for1 in my 2012 ford f150? Guide 27881 (updated from 10981 as suggested with the paper included with the Thar-for1) or guide # 32131? I've tried to install it as per guide# 32131 but the blue light won't flash rapidly once the key is turned to the on position. Also, do i have to connect the parking light wires or can I just connect the can high, can low, lock, unlock, door pin and the yellow/blk, lt blue, lt blue/blk wires from the thar-for1 harness to the evo?

Answer 1

parking lights are not required for remote starting.

32131 is right installation guide. ( http://fortin.ca/download/34421/evo-all_thar-ford_ford80bits_standalone_b20150706.pdf )

 

If the blue LED is not flashing at the end, it's possible that the Can-Bus wires are reversed or the connections need to be redone. You should be able to test about 2.X Vdc on either grey or grey/black of the evo-all when ignition is on. it's also possible the module is not seeing ignition; in this case you would have to test the yellow wire of the evo-all to see if an ignition signal is present.