R Link module connection

Question

I have download the the instructions for the EVO-VWT1 with T-harness. I have updated both the flash link updater and EVO as a standalone. Looking at the instructions, I don't see where the hi and low can bus wires are used. It also does not say how to connect and program the R-Link module. The instructions said need the following connections: yellow (power), yellow/red (brake) and the two wrap wires ((white/red and white/blue. Am I missing anything else?

Answer 1

The r link plugs into were the tb-vw goes. Once programming is finished you remove the r link and plug back in the tb-vw and that stays in the vehicle and you keep the r-link for the next vw/audi vehicle.

 
 

This is the installation guide for 3x lock start: https://fortin.ca/download/82591/evo-all_ig_tsa_bi_vw1-a3-s3_2015-2016_pts_tb_a_82591.pdf

 

The following wires must be manually connected:

 

1- start/stop

2- transponder interrupt

3- can wires

4- brake wire

 

The hazard light connection is optional.