THAR-AUD2 & Evo-All, How to Program

Question

I just want to use the remote start function of lock button*3.
I have an Evo-All module and a Thar-Aud2 harness.
I connected this harness to the cable in the trunk side while looking at the installation manual, and I connected the extra remote control key.
And I connected the black connector while pressing the module's program button, but the lights on the all LED are flashing blue, red, and green. It's the same when I take my hands off.

Even if I reconnect all the connectors, the same thing happens.
The program doesn't work at all. What's the problem?
Do I not have to use a black connector to just use the lock button*3?

Please help me

Answer 1

Hello,

Sounds like your module isnt flashed yet.

You must flash and configure it before attempting in vehicle programming.

Best regards.

Comments

Hello! Thank you for your reply.
So if I buy FLASHLINK4 and flash it to the module, will it solve everything?