I get to step 5 to insert key the light stays yellow doesn't turn red

Question

i get all the way to step 5 where i have to insert the key then it should turn red but it doesnt it just stays yellow i when back to step 1 like it said and started over like 10 times still the same

Answer 1

Here's some things you can look at. 

• Test the yellow wire on the EVO for ignition. 
• Redo the connections of the light blue and light blue black wires. Key data is on the light blue/black wire. 
• You can test your Can-Bus connections by programming only the Can-Bus. If can-bus programs, connections for can-hi and can-lo are ok. To do this simply release when the LED is blue, plug in all the connectors, and turn ignition on. If the blue led starts to flash , then can-bus connections are ok. 
• A master reset never hurt either: http://fortin.ca/en/qa/50193/faq-how-do-i-reset-my-evo-all

Comments

i see i didnt connect to light blue wires to the harness from the 20 pin harness

Answer 2

Your connections are likely wrong at the ignition then. What vehicle type and what unit(s) are you using to try and achieve remote start?

Comments

2015 ram 1500 tip key and evo all model with thar-chr6 wiring harness got ignition wire connected to pink with green strip and the can 1 and 2 connected to the right ones also yellow and gray wires i watched the vidoe didnt everything he did and read the install papers all the step are good till step 5 when i put the key in it just stays yellow does turn red

---

Make sure you have the LT Blue and the LT blue/black wires connected from the 20 pin to the T-harness.