2011 G37 sedan automatic

Question

I will be buying the Stand Alone EVO ALL system. I do not need anything else, no remote starter or anything?  Just wire up the Stand Alone EVO all and it should be all set?

Answer 1

Hi Sam,

 

That is correct, the only module you would have to install is the EVO-ALL. Installing a hood pin and/or valet switch for the safety of those working on your engine is also strongly recommended.

 

You will want to take some little pointers into consideration.

 

1. There is a minimum firmware requirement which is firmware 4.18. Currently we ship the EVO-ALL units with firmware 4.18 already loaded on it to our direct distributeurs.
2. The EVO-ALL does not come with the Stand Alone feature activated. This needs to be done using the Flash-Link Updater.

Comments

I have installed many remote starters in the past, more than capable. I was even on the phone with Fortin last night and the guy said the unit is most likely defective if it will not reset.  The unit is capable of being flashed but it will not reset according to the procedure.

---

http://www.the12volt.com/installbay/forum_posts.asp~TID~135309~PN~1

You should reconnect the Tx wire while you wait for the new EVO.

---

I reconnected the wire for the TX connection.  The key light is still there when I start the car. Any ideas?

---

Ok light has gone away. Disconnected the battery for 30 minutes. I will report back when the new EVO ALL comes in.

---

Ok the new EVO ALL came and I programmed it and installed it. It works great.  3x lock and it starts, 3x lock again and it stops it.  Thank you greatly for your help, I knew what I was doing was correct, I suspected the old EVO was defective.

One question I have is when I remote start the car and it times out (set to 15 min) or if I stop it, the car unlocks.  Is there anyway I can make it lock on shutdown?