Chick engine flashing

Question

Hi sir am working on Dodge Charger 2015 it's complete working and car starting engine normally but we found chick engine flashed ,we read it by diagnostic tool and found

U0415 invalid data received from Anti-lock break system control module

we erase it and start by PTS no errors come once we start  engine by 3lock errors come

this problem comes in jeep and dodge 2014 and more , any help

Answer 1

What is the service number to the module?

Comments

001A06696507

---

If you flash to 0.81, you will need to disconnect your parking light wire from the evo and connect it to the brake wire just like in the installation guide for a dodge durango 2015 pts, guide number 59471. we send a signal on the brake wire.

Please verify the brake wire you are hooking up to with a digital voltmeter, It is the wire that gives around 2-5v when the brake pedal is pressed with ignition ON

---

Hi sir , I need to restore evo all to default because the costumer take one device and accept chick engine  and leave the device was updated with 0.81 so can we solve it to  the default because when I updated to last recomanded update wasn't work , thank you

---

I suggest doing a master reset as shown here: http://wirecolor.com/en/qa/50193/faq-how-do-i-reset-my-evo-all?show=50193#q50193

 

Then flash the evo to 74.18 and re program the module and re test.

 

If you are still experienceing issuse after having done this please call us toll free at 1-877-336-7797 for furhter troubleshooting.

---

This module item defected know dosnt work any more

---

So the module worked but somehow went defective?

Did you determine what casued the module to fail? I ask only because they don't go "defective" for no reason especially when it was working.

---

I know the the cause off flashing 0.81 it wasn't work after that we need to solve chick engine problem these version maybe wasn't tested will

---

If your going to attempt to install on this vehicle I would suggest testing wires first. Follow the guide here if using t-harness and evo-all stand alone:http://fortin.ca/download/12211/evo-all_ig_tsa_bi_chr6-charger-journey-300_2011-2014_pts_d_12211.pdf

and use firmware 74.18 only.