2016 Kia Rio (standard key) / Evo One / Revo-1

Question

I've tried everything and can't get this to work.

If I try to set it up to use the OEM keyless entry remote, nothing works.

If I try to set it up to use the Revo-1 RF remotes, I can get it to talk to the canbus enough to recognize the brake pedal presses while going through the steps to pair the remotes, but nothing else.

Is there a different 1-button remote I should get instead?  Or some combination of options that will make the OEM remote work?

Answer 1

What is the service number to the module?

Comments

002B07

 

Firmware was current (as recommended for the car by the flashlink software) as of a couple of weeks ago

---

that is only half the service number....need the last 6 as well.

---

002B07 133980

 

Sorry, looked like it switched fonts after the gap so I thought it was a different number.

---

3x lock not working is normal, seeing as it is not supported on this vehicle.

 

If the revo1 remotes do not program try lowering the remote starter firmware to 1.16 and re program the remotes.

 

Also I see you tuend off key bypass in the bypass options...does the vehicel not have an immobilizer?

---

I'll give the firmware downgrade a try when I get home.

It is the standard key model, no chip.

---

Downgraded to 1.16.  No difference.

Initial programming of the Evo completes successfully with the blue light.  Then I try to program the remotes:

https://www.manualslib.com/manual/1076524/Crimestopper-Revo-1-Series.html?page=8#manual

5th click of the valet button causes a double pulse of the relay, and nothing happens after pressing the brake pedal, no response when pressing or holding remote buttons, etc.  If I keep pressing the valet button, the cycle repeats.  One relay click per press for 4 presses, then a double click.

---

At this point you would be best to call tech support 1-877-336-7797