Evo all programming

Question

Installing evo all on 2011 Toyota Sienna with g key all wiring installation followed on Fortin diagram when processing the program step by step red and blue led will stay on and press the button twice as per instructions after all connections are made  both led will not going to flash that supposed to be flash to proceed the programming double check all connections no fault found! What next step or suggestion

Answer 1

You need to update the firmware in the module. It is still at 4.18, you need at least the minimum listed in the guide.

 

Your module can be seen here: http://fortin.ca/en/support/001A06745094/#

Comments

I GOT THE MODULE UPDATE WITH FLASH LINK 4, PROGRAM FINISH, VEHICLE WAS STARTING WITHOUT THE KEY, BUT JUST ONLY 10 SEC, THEN SHUT DOWN, RE START AGAIN, ALSO RED AND YELLOW LED LIGHT ON WHEN  ENGINE RUNNING, ALL WIRING FOR BYPASS WAS FOLLOWED, REVIEW THE EVO ALL OPTION BASE ON THE FIXED MESSAGES  FOUND OPTION D1 WAS OFF AND D1.5-7 MINUTES RUN TIME SHOULD BE ON, BUT ON  THE ACTUAL FLASH LINK MANAGER D1 WAS OFF AND THE D1.1 TO D1.6 WAS BLANK, NEED TO TURN ON THE D1 BEFORE TO ACCESS THE RUN TIME MODE, PROBLEM IS IF THE D1 WAS ON TO ACCESS D1.5 TO TURN ON, VEHICLE WILL NOT START, UPDATE IT AGAIN AND TURN OFF THE D1 OPTION, VEHICLE WILL START BUT BACK TO ZERO AGAIN IT WILL TURN OFF AFTE FEW SECONDS, HOW CAN I SET THE RUN TIME WITHOUT TURNING ON THE D1 OPTION AS PER SHOWN ON THE FIX LINK TO SEE THE STATUS,

THANKS