what is the black data plug wire colors and funtion? Cat get past step7 in programming.

Question

2016 Jeep Cherokee stand alone remote start. using evo all & chrt 6 Tharness  i get to step 7 but blue light never comrs on. also can you tell me the function of the 4 wires in the black data plug? this harness did not have te plug so I found a plug that fit and wired the red wire to 12 volts, the black wire to ground, do I need the other 2 wires? if so what are their colors and function? Thanks

Answer 1

When using evoall with chrt6 in standalone the 2 other wires are not used. They are data communication between the evoall and  a rfkit antenna or remote starter.

Comments

So the wires I hooked up are correct, red+,  black- ? And since I cant get past step 6, key programming, Im guessing, I probalbly need to check my can bus wires @ the diagnotic port in truck? I have a  question about flashing/programming module with encrypter , it seems when im in the  remote start mode,it says evo all is not connected, but when in the other mode,  I can turn on/off the options I want I can click save ok, if I click Flash nothing happens/ The truck is a 2016 Jeep Cherokee Sport, do you know if this has a interior temp sensor? , Ive looked & looked but cant find one/ Diagrams/pics show it to be at lower dash just under key cylinder/ Oh........,and Thank You Very Much for taking the time to answer my questions. Very Helpful! Thanks Again, Mike