Evo One Can Bus Data programming not flashing blue?

Question

Hi all,

 

I have installed the evo one inside my Sonata Limited 2016 PTS and went through the procedure outlined in the following page:

http://fortin.ca/en/vehicles/hyundai/sonata/2018-push-to-start/troubleshooting.html

Step 1: The module does not program correcty.

Step 2: Step 5-6.

Step 3: Blue led does not flash properly.

Essentially, in step 5, when I start the ignition to on, the red LED flashes 10 times. Up to this point, everything is fine. Subsequently, instead of the blue LED flashing, I get both red and blue LED lighting up and remain as is. It only turns off when I turn off the ignition.

 

I double checked my wiring but it does not seem to be the case. Would you have any suggestion?

 

Best regards,

 

Franck

Answer 1

Need to update the firmware. Minimum is 76.36 and your unit is currently at 4.18

Comments

I have now managed to have the vehicle to start cranking following the 3x lock press but it won't start.

Do you have any suggestion?

 

Thanks!