Does evo all lose programming if unplugged?

Question

Installed evo all with autopage remote start, i already had a remote start installed but replaced it, i took out evo all for about a week i don't know if i have to reprogram it or if something is lose, remote start will work but next day it will start a shut off in about 5sec, i will relearn the tach and it will work again. Will wire to wire just for tach help? Can i check if evo all is putting out tach signal?

Answer 1

Yes you can check the evo to see if it is outputting tach.

 

With a multimeter probe the tach wire on the evo, you should see a voltage drop when starting the vehicle.

OR

TEST ONE: http://fortin.ca/en/products/accessories/test-one/

Comments

Should i update evo all to latest version? Guide i used shows ground while running connected new guide doesn't , its in dotted line. If i update evo do i need to disconnect the gwr wire? Also will tach wire work w2w in data mode? Remote starter is set to tach data mode should I change it to tach mode? 2013 civic

---

you should not need to update the evo.

---

Thank you for your reply

Answer 2

If reprogramming tach on your autopage fix, the issue, the autopage is losing tach programming when it's disconnected. You should contact autopage.